Cytat:
Napisał pku
|
cytując samego Ciebie: tu masz opis (i wzór) jak to obliczyć bez rozbierania.
Cytat:
|
Napisał peterverdone
Increments should be no more than 2-3mm at a time. Oil can be added to the fork while it is in place on the bike just by removing the top caps. Since the height cannot be measured when the fork is on the bike, note the starting height and add by cc's. The volume of cc's can be approximated to mm of oil height by mm=cc/(Pi*r^2) when r is the radius of the inside of the fork tube. Next time the fork is of the bike, re-measure the oil height. This is the new oil height.
Whenever possible, know what volume of oil you are running in your fork to achive the desired height. By draining oil out the bottom of the fork via the slow speed compression adjuster and refilling through the cap, you can oil tune very rapidly compared to a full fork dissassembly. For the racer, this is a MUST. If this oil tuning is being done for reasons other than temperature change, you may have to decrease the height when using a thicker oil and vis-a-vis
|
__________________
pozdrawiam, podos
AT2003, RD07A
------------------
Moje dogmaty
0. O chorobach Afryki: ( klik)
1. O Mikuni: Wywal to.
2. O zębatce: Wypustem na zewnątrz!!!
3. O goretexie: Tylko GORE-TEX
4. O podróżach: Jak solo to bez kufrów
5. O łańcuszkach rozrządu: nie zabieram głosu.
6. Lista im. podoska Załącznik 10655
7. O BMW: nie miałem, nie znam się, nie interesuję się, zarobiony jestem.
8. O KN: Wywal to.
9. O nowej Afripedii: ( klik)
|